FixVault
Home › Lexus › 2008 › LS 600hL › Repair and Diagnosis › Engine Mechanical › Lubrication System › Lubrication › Oil Pressure Switch › Installation

Oil Pressure Switch: Installation

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the switch.

      Adhesive: 

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent 

      Fig 1: Applying Adhesive To Threads Of Switch
      G05773427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 24 mm deep socket wrench, install the switch.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE: Do not start the engine within 1 hour after installation.
    3. Connect the switch connector.
      Fig 2: Removing/Installing Oil Pressure Switch
      G05773428Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT FOR OIL LEAK 
    1. Start the engine Make sure that there are no oil leaks from the area that was worked on.
  3. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH  (See INSTALLATION )
  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH  (See INSTALLATION )
About FixVault