FixVault
Home › Lexus › 2008 › LS 600hL › Repair and Diagnosis › Transmission › Automatic Trans › Hybrid Transaxle - Service Information › Hybrid Mode Select Switch › Installation

Hybrid Mode Select Switch: Installation

  1. INSTALL COMBINATION SWITCH ASSEMBLY 
    1. Install the combination switch assembly with the 4 claws.
      Fig 1: Identifying Combination Switch Assembly Claws
      G05781115Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INSTRUMENT PANEL CUP HOLDER 
    1. Install the instrument panel cup holder with the 4 screws.
      Fig 2: Locating Instrument Panel Cup Holder Screws
      G05781114Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the combination switch connector.
      3. Fig 3: Locating Combination Switch Connector
      G05781113Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR UPPER CONSOLE PANEL  (See INSTALLATION )
  4. INSTALL NO. 3 BOX PANEL  (See INSTALLATION )
  5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  9. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
About FixVault