Oil Pump Motor Controller: Installation

INSTALL OIL PUMP MOTOR CONTROLLER
CAUTION: Be sure to perform the procedure as described below. Do not turn the power switch on (READY) before reconnecting the cable to the negative battery terminal.
1. Install the oil pump motor controller with the 3 bolts.
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 1: Locating Oil Pump Motor Controller With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the clamp to the bracket.
  
  Fig 2: Identifying Oil Pump Motor Controller Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil pump motor controller with bracket with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 3: Locating Oil Pump Motor Controller Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the connector and securely lock the lock lever as shown in the illustration
  NOTE:
  - Be sure to securely lock the claw on the connector.
  - Push the connector all the way in and lock the lock lever.
  HINT.
  
  When the connector is pushed all the way in, the lock lever will move slightly to the lock position
  
  Fig 4: Identifying Oil Pump Motor Controller Connector Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Push in the lever to securely engage the lock on the connector
  
  Fig 5: Pushing Oil Pump Motor Controller Connector Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the connector to the oil pump motor controller.
  
  Fig 6: Locating Oil Pump Motor Controller Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the connector and securely lock the lock lever as shown in the illustration.
  NOTE:
  - Be sure to securely lock the claw on the connector.
  - Push the connector all the way in and lock the lock lever.
  HINT.
  
  When the connector is pushed all the way in, the lock lever will move slightly to the lock position.
  
  Fig 7: Identifying Oil Pump Motor Controller Connector Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Push the lock into the lock lever to securely lock the lock lever on the connector.
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).

Fig 8: Pushing Oil Pump Motor Controller Connector Lever
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )