Radio Receiver: Installation

INSTALL NO. 2 RADIO BRACKET
1. Install the bracket with the 3 bolts.
  Torque: 3.0 N*m (30 kgf*cm, 26 in.*lbf)
  
  Fig 1: Locating No. 2 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 RADIO BRACKET
1. Install the bracket with the 3 bolts.
  Torque: 3.0 N*m (30 kgf*cm, 26 in.*lbf)
INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
1. Connect the connectors.
2. Insert the radio receiver to attach the 7 claws on its backside.
  NOTE: When inserting the radio receiver, do not press the knobs on it.
  
  Fig 3: Identifying Radio Receiver Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the radio receiver with the 2 screws and 2 bolts.
  Torque: for bolts labeled A
  
  12 N*m (122 kgf*cm, 8 ft.*lbf)
  
  Fig 4: Locating Radio Receiver Screws And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET (w/o Navigation System) (See INSTALLATION )
INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET (w/ Navigation System) (See INSTALLATION )
INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )