Front Door Lock: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH  (See REASSEMBLY )
2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH  (See REASSEMBLY )
3. INSTALL FRONT DOOR LOCK ASSEMBLY LH 
   Fig 1: Identifying Screws And Door Lock

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Apply MP grease to the sliding parts of the front door lock assembly.
   2. Insert the front door lock open rod into the front door lock assembly.
   3. Make sure that the front door lock open rod is securely connected to the front door lock assembly.
   4. Using a T30 "TORX" wrench, install the door lock with the 3 screws.

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH  (See REASSEMBLY )
5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH  (See REASSEMBLY )
6. INSTALL FRONT NO. 2 DOOR STIFFENER CUSHION  (See REASSEMBLY )
7. INSTALL FRONT DOOR SERVICE HOLE COVER LH  (See REASSEMBLY )
8. INSTALL DOOR TRIM COVER LH  (See REASSEMBLY )
9. INSTALL FRONT DOOR PANEL CUSHION  (See REASSEMBLY )
10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (See REASSEMBLY )
11. INSTALL COURTESY LIGHT ASSEMBLY  (See INSTALLATION )
12. INSTALL FRONT UPPER ARMREST BASE PANEL LH  (See REASSEMBLY )
13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH  (See REASSEMBLY )
14. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH  (See REASSEMBLY )
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
16. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (See DIAGNOSIS SYSTEM ).
17. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )