Front Seat Assembly: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL FRONT SEAT ASSEMBLY LH 
   1. Place the front seat assembly in the cabin.
      NOTE: Be careful not to damage the vehicle body.
   2. Connect the seat wire connectors under the seat.
   3. Connect the cable to the negative (-) battery terminal.
      NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
   4. Temporarily install the front seat assembly with the 4 bolts
   5. Operate the power seat switch (slide switch) to move the seat to the rearmost position.
   6. Tighten the bolts in the order shown in the illustration.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 1: Tightening Power Seat Switch Bolts (Moving Seat To Rearmost Position)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   7. Operate the power seat switch (slide switch) to move the seat to the foremost position.
   8. Tighten the bolts in the order shown in the illustration.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

      Fig 2: Tightening Power Seat Switch Bolts (Moving Seat To Foremost Position)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH 
   1. Attach the 2 claws to install the cover.
      Fig 3: Attaching Claws To Rear Inner Seat Track Bracket Cover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH 
   1. Attach the 2 claws to install the cover.
      Fig 4: Attaching Claws To Rear Outer Seat Track Bracket Cover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH 
   1. Attach the 2 claws to install the cover.
      Fig 5: Identifying Inner Seat Track Bracket Cover Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH 
   1. Attach the 2 claws to install the cover.
   2. Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See CUSTOMIZE PARAMETERS ).
   Fig 6: Attaching Claws To Rear Outer Seat Track Bracket Cover
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL FRONT SEAT HEADREST ASSEMBLY 
7. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
8. CHECK SRS WARNING LIGHT 
   1. Check the SRS warning light (See DIAGNOSIS SYSTEM ).
9. INSPECT FRONT SEAT ASSEMBLY 
   1. Check the power seat operation (See OPERATION CHECK  )
   2. Check the seat heater operation.
      1. Turn the engine switch on (IG).
      2. Turn the seat heater switch on.
      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.
   3. w/ Climate Control Seat System:

      Check the climate seat operation (See OPERATION CHECK  ).