Vane Pump: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE: w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE FRONT WHEEL RH
REMOVE FRONT FENDER APRON SEAL FRONT RH (See REMOVAL )
REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER HOSE ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER ASSEMBLY (See REMOVAL )
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
DRAIN POWER STEERING FLUID
DISCONNECT SUCTION HOSE
1. Slide the clip and disconnect the suction hose from the vane pump.
  
  Fig 1: Locating Suction Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
1. Detach the wire harness clamp and disconnect the connector.
  
  Fig 2: Locating Power Steering Oil Pressure Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT PRESSURE FEED TUBE
1. Remove the bolt and disconnect the pressure feed tube.
2. Remove the gasket.
  
  Fig 3: Locating Pressure Feed Tube Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VANE PUMP ASSEMBLY
1. Remove the 2 bolts and vane pump.
  
  Fig 4: Locating Vane Pump Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002