Oil Pump: Reassembly

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal to the oil pump body.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flush with the outer edge of the oil pump.
2. Coat the lip of the oil seal with MP grease.
  
  Fig 1: Tapping Oil Seal To Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF and install it to the oil pump body.
  NOTE: Make sure that the O-ring is not twisted or pinched. Apply enough ATF to the O-ring before installation.
  
  Fig 2: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 3: Identifying Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set the stator shaft and align it with each bolt hole.
2. Using a "TORX" socket (T30), install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Locating Bolts And Stator Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new clutch drum oil seal rings with ATF.
2. Install 2 new clutch drum oil seal rings.
  NOTE: Do not expand the ring ends excessively.
  
  Fig 6: Identifying Clutch Drum Oil Seal Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )