Transmission Wire: Installation

1. Coat a new O-ring of the transmission wire connector with ATF and install it.
   Fig 1: Locating O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission wire with the bolt.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   Fig 2: Identifying Transmission Wire With Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring of the ATF temperature sensor with ATF.
2. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

3. Connect the 7 shift solenoid valve connectors.
   Fig 3: Locating Shift Solenoid Valve Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the 2 magnets in the oil pan.
2. Apply adhesive to the 18 bolts.

   Adhesive: 

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent 

   Fig 4: Identifying Magnets In Oil Pan

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.

   Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

   NOTE: Apply adhesive to the bolts and tighten them within 10 minutes of application.
   Fig 5: Identifying Bolts Of Oil Pan

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

(See INITIALIZATION  )

HINT:

Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).