Rear Combination Light Assembly: Installation

HINT:

• Use the same procedures for the RH and LH side.
• The procedures listed below are for the LH side.

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH 
   1. Attach the rear combination light with the 2 pins and install the light guide of the body side.
      Fig 1: Identifying Rear Combination Light Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connector.
      Fig 2: Locating Combination Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR LIGHT COVER LH 
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE LH  (See REASSEMBLY )
4. INSTALL REAR FLOOR FINISH SIDE PLATE LH  (See REASSEMBLY )
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT  (See REASSEMBLY )
6. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LOWER  (See REASSEMBLY )
7. INSTALL TONNEAU COVER ASSEMBLY  (See REASSEMBLY )
8. INSTALL LUGGAGE COMPARTMENT TRIM REAR COVER SUB-ASSEMBLY  (See REASSEMBLY )
9. INSTALL TOOL BOX COVER  (See REASSEMBLY )
10. INSTALL SPARE TIRE 
11. INSTALL SPARE WHEEL COVER ASSEMBLY 
12. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH  (See REASSEMBLY )
13. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH  (See REASSEMBLY )
14. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
15. INSTALL REAR FLOOR FINISH PLATE  (See REASSEMBLY )
16. INSTALL TONNEAU COVER STOPPER SUB-ASSEMBLY LH  (See REASSEMBLY )
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
18. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.