FixVault
Home › Lexus › 2008 › SC 430 › Repair and Diagnosis › External Pages › Different car › Section 33 (Audio/Visual) › Radio Antenna Holder › Installation

Radio Antenna Holder: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WITH HOLDER ANTENNA ASSEMBLY 
    1. Install the antenna with the nut.
    2. Connect the connector and plug to the antenna.
      Fig 1: Identifying Antenna And Nut
      G05293156Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the antenna ornament with the nut.
      Fig 2: Identifying Antenna Ornament Nut
      G05293157Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE RH (See  INSTALLATION  ) 
  3. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT (See  INSTALLATION  ) 
  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LOWER (See  INSTALLATION  ) 
  5. INSTALL TONNEAU COVER ASSEMBLY (See  INSTALLATION  ) 
  6. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY REAR (See  INSTALLATION  ) 
  7. INSTALL TOOL BOX COVER (See  INSTALLATION  ) 
  8. INSTALL SPARE WHEEL COVER ASSEMBLY 
  9. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH (See  INSTALLATION  ) 
  10. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH (See  INSTALLATION  ) 
  11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
  12. INSTALL REAR FLOOR FINISH PLATE (See  INSTALLATION  ) 
  13. INSTALL TONNEAU COVER STOPPER SUB-ASSEMBLY RH (See  INSTALLATION  ) 
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  15. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
About FixVault