FixVault
Home › Lexus › 2008 › SC 430 › Repair and Diagnosis › External Pages › Different car › Section 46 (Navigation) › Navigation Antenna › Removal

Navigation Antenna: Removal

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE (See  REMOVAL  ) 
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. INSPECT CENTER FRONT WHEEL 
  4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 
    1. Remove the instrument panel safety pad (see REMOVAL ).
  5. REMOVE STEERING COLUMN ASSEMBLY (See  DISASSEMBLY  ) 
  6. REMOVE NO. 1 INSTRUMENT PANEL PIN (See  DISASSEMBLY  ) 
  7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT (See  DISASSEMBLY  ) 
  8. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT (See  DISASSEMBLY  ) 
  9. REMOVE FRONT DEFROSTER NOZZLE (See  DISASSEMBLY  ) 
  10. REMOVE NO. 1 HEATER TO REGISTER DUCT (See  REASSEMBLY  ) 
  11. REMOVE NO. 3 HEATER TO REGISTER DUCT (See  REASSEMBLY  ) 
  12. REMOVE NO. 2 HEATER TO REGISTER DUCT (See  REASSEMBLY  ) 
  13. REMOVE INSTRUMENT PANEL REINFORCEMENT (See  REASSEMBLY  ) 
  14. REMOVE NAVIGATION ANTENNA ASSEMBLY 
    1. Remove the 2 clamps.
    2. Remove the 2 screws and antenna.
      Fig 1: Locating Navigation Antenna Screws
      G05293379Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault