Toe Control Link: Installation: Installation

1. Install the toe control link and insert the toe adjust cam from the front of the vehicle. Then, install the rear No. 2 suspension toe adjust plate and temporarily tighten the nut.
   Fig 1: Identifying Matchmarks On Rear No. 2 Suspension Toe Adjust Plate And Rear Suspension Member

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   Align the matchmarks on the rear suspension member and rear No. 2 suspension toe adjust plate.

   HINT: 

   Fully tighten the nut after stabilizing the suspension.

2. Install the rear suspension toe control link with a new nut.
   Fig 2: Identifying Rear Suspension Toe Control Link And Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 

1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply a load to the rear suspension so that the rear drive shaft assembly becomes level.
   Fig 3: Inspecting Suspension

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Fully tighten the nut on the rear suspension member side.
   Fig 4: Identifying Matchmarks On Rear No. 2 Suspension Toe Adjust Plate And Rear Suspension Member

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf) 

   NOTE:

   Check that the matchmarks on the rear suspension member and rear No. 2 suspension toe adjust plate are aligned.

2. Install the skid control sensor wire with the bolt.
3. Connect the skid control sensor connector.
   Fig 5: Identifying Skid Control Sensor Connector And Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

Refer to ADJUSTMENT