FixVault
Home › Lexus › 2009 › IS F › Repair and Diagnosis › Brakes › Traction Control › Brake Control (Service Information) › Yaw Rate And Acceleration Sensor › Removal › Removal

Yaw Rate And Acceleration Sensor: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  . Refer to REMOVAL - Step 4
  3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH  . Refer to REMOVAL - Step 5
  4. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH  . Refer to REMOVAL - Step 6
  5. REMOVE CONSOLE PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 7
  6. REMOVE FRONT ASH RECEPTACLE ASSEMBLY  . Refer to REMOVAL - Step 8
  7. REMOVE REAR ASH RECEPTACLE ASSEMBLY  . Refer to REMOVAL - Step 7
  8. REMOVE CONSOLE BOX REGISTER ASSEMBLY  . Refer to REMOVAL - Step 8
  9. REMOVE CONSOLE BOX  . Refer to REMOVAL - Step 9
  10. REMOVE NO. 2 CONSOLE BOX DUCT  . Refer to REMOVAL - Step 42
  11. REMOVE YAW RATE AND ACCELERATION SENSOR 
    1. Separate the 2 wire harness clamps.
      Fig 1: Locating Bolts And Yaw Rate And Acceleration Sensor
      GTY109036Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and yaw rate and acceleration sensor.
    3. Disconnect the yaw rate and acceleration sensor connector.
      Fig 2: Locating Yaw Rate And Acceleration Sensor Connector
      GTY109037Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not remove the sensor from the bracket.

About FixVault