Hazard Warning Switch: Inspection

INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

LED illumination inspection

Apply battery voltage to the terminals of the connector, and check the LED illumination condition.

Fig 1: Identifying Hazard Warning Signal Switch Assembly Connector Terminal ILL+ And ILL-

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HAZARD WARNING SIGNAL SWITCH ILLUMINATION CONDITION

Tester Connection	Specified Condition
1 (ILL+) - 5 (ILL-)	Night illumination comes on

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE SPECIFIED CONDITIONS

Tester Connection	Switch Condition	Specified Condition
7 (HAZ) - 6 (GND)	Hazard warning signal switch OFF	10 kΩ or higher
7 (HAZ) - 6 (GND)	Hazard warning signal switch ON	Below 1 Ω

If the result is not as specified, replace the hazard warning signal switch.

Fig 2: Identifying Hazard Warning Signal Switch Assembly Connector Terminal HAZ And GND