POWER WINDOW REGULATOR MOTOR (for Front Door): Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See INSTALLATION )
2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH  (See INSTALLATION )
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH  (See INSTALLATION )
4. INSTALL FRONT DOOR SERVICE HOLE COVER LH  (See INSTALLATION )
5. INSTALL DOOR FRAME GARNISH LH  (See INSTALLATION )
6. INSTALL FRONT DOOR TRIM COVER LH  (See INSTALLATION )
7. INSTALL COURTESY LIGHT ASSEMBLY  (See INSTALLATION )
8. INSTALL FRONT DOOR INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY LH  (See INSTALLATION )
9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (See INSTALLATION )
10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See INSTALLATION )
11. INSTALL DOOR INSIDE HANDLE BEZEL PLUG  (See INSTALLATION )
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
       NOTE:

       • When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
       • After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
         1. Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.
         2. Open the power window by fully pushing down the switch.