FixVault
Home › Lexus › 2009 › LS 600hL › Repair and Diagnosis › External Pages › Different car › Section 25 (Cruise Control) › Object Recognition Ecu › Removal

Object Recognition Ecu: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See REMOVAL ).
  2. REMOVE BATTERY SERVICE HOLE COVER LH  (See REMOVAL ).
  3. REMOVE BATTERY SERVICE HOLE COVER  (See REMOVAL ).
  4. REMOVE ROPE HOOK  (See REMOVAL ).
  5. REMOVE ROPE HOOK ASSEMBLY  (See REMOVAL ).
  6. REMOVE DECK TRIM SIDE BOARD RH  (See REMOVAL ).
  7. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL ).
  8. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See REMOVAL ).
  9. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler)  (See REMOVAL ).
  10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER  (See REMOVAL ).
  11. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See REMOVAL ).
  12. REMOVE OBJECT RECOGNITION ECU 
    1. Disconnect the 2 connectors.
    2. Remove the 2 bolts.
    3. Detach the 2 clips and remove ECU.
    NOTE: Do not drop the ECU or subject it to strong shocks.
    Fig 1: Locating Object Recognition ECU Connector Bolt And Clip
    G05776075Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
About FixVault