FixVault
Home › Lexus › 2009 › LS 600hL › Repair and Diagnosis › External Pages › Different car › Section 34 (Door Lock) › Door Control Transmitter › Installation

Door Control Transmitter: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMITTER BATTERY (for Card Type) 
    1. Push in and install the transmitter battery (lithium battery (CR2412)) while being careful of the following 1) the battery's positive (+) and negative (-) terminals; and 2) being sure to insert the battery between the 2 terminals and deep into the card, in the direction of the arrow.

      HINT:

      Check if the card's terminals are damaged or if the card's interior has foreign matter

      NOTE:
      • Insert the battery so that its positive (+) side is facing the LEXUS mark.
      • Do not deform the terminals.
      • If the terminals are dirty, wipe the terminals with a soft cloth before installing the battery.
        Fig 1: Installing Transmitter Battery - Lithium Battery (CR2412)
        G05765320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the transmitter housing cover so that it clips onto the case
      NOTE:
      • Push on the transmitter cover until its attachment hooks attach securely.
      • When the transmitter cover is removed and installed many times, be careful as the cover may become loose.
        Fig 2: Installing Transmitter Housing Cover
        G05765321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TRANSMITTER BATTERY 
    1. Install a battery (lithium battery CR1632) with the positive (+) side facing upward, as shown in the illustration.
      NOTE:
      • Do not bend the transmitter battery electrode during insertion.
      • Keep the transmitter cover interior free of dust and oil.
        Fig 3: Identifying Battery (Lithium Battery CR1632) With Positive Side
        G05765322Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the transmitter housing cover by pressing down on it as shown in the illustration.
      Fig 4: Installing Transmitter Housing Cover
      G05299289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Insert the mechanical key into the transmitter.
    4. Press one of the transmitter's switches and check that the LED illuminates
About FixVault