Front Door Window Frame Moulding: Installation

HINT

• Use the same procedures for the RH side and LH side
• The procedures listed below are for the LH side.

1. INSTALL FRONT DOOR FRONT WINDOW FRAME MOULDING LH 
   1. Attach the clip to install the window frame moulding.
   2. Install a nose piece to an air riveter or hand riveter Then insert the mandrel part of a new Ø 4 mm waterproof rivet into the nose piece.
   3. Using the air riveter or hand riveter, install the 6 rivets shown in the illustration

      HINT

      • As there are 2 types of rivets, be sure to install the rivets to the correct locations.
        RIVET REFERENCE
        
        

        Rivet	Rivet Type
        (A)	Short Type or Long Type
        (B)	Long Type

      • If the rivet cannot be cut, pull it once and cut it.
   Fig 1: Installing Front Door Front Window Frame Moulding

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   • Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
     Fig 2: Identifying Riveter Correct And Incorrect Position

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   • Confirm that the rivets are seated properly against the moulding.
   • Do not tilt the riveter when installing the rivet to the moulding.
   • Do not leave any space between the rivet head and moulding.
     Fig 3: Identifying Riveter Correct And Incorrect Position

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   • Do not leave any space between the moulding and door frame. Firmly hold together the 2 items while installing the rivet.
   Fig 4: Identifying Riveter Correct And Incorrect Position
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT NO. 2 DOOR WEATHERSTRIP LH 
   Fig 5: Identifying Front Door Front Window Frame Moulding LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Clean the front door surface
      1. Remove the double-sided tape from the front door
      2. Wipe off any tape adhesive residue with cleaner
   2. Install a new No. 2 weatherstrip
      1. Remove the peeling paper from the face of the No. 2 weatherstrip

         HINT

         After removing the peeling paper, keep the exposed adhesive free from foreign matter

      2. Install the No. 2 weatherstrip with the clip

         HINT.

         Lift up the No. 3 weather strip to install the No. 2 weatherstrip, as the No. 2 weatherstrip affixes to the inner side of the No. 3 weatherstrip

3. INSTALL FRONT DOOR REAR BELT MOULDING END COVER LH  (See INSTALLATION )
4. INSTALL DOOR FRAME GARNISH LH  (See INSTALLATION )
5. INSTALL FRONT DOOR TRIM COVER LH  (See INSTALLATION )
6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (See INSTALLATION )
7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY  (See INSTALLATION )
8. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH  (See INSTALLATION )