Rocker Panel Moulding: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT.

Use the same procedures for the RH side and LH side
The procedures listed below are for the LH side.

INSTALL ROCKER PANEL MOULDING LH
1. Attach the 11 clips to install the moulding
  
  Fig 1: Identifying Moulding Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws
  
  Fig 2: Identifying Moulding Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 8 clips.
  
  Fig 3: Identifying Rocker Panel Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the screw on the rear side.
  
  Fig 4: Identifying Rear Side Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the screw on the front side.
Fig 5: Identifying Front Side Screw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR NO. 3 DOOR WEATHERSTRIP LH
1. Attach the 13 clips to install the weatherstrip.
Fig 6: Identifying Weatherstrip Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 6 ROCKER PANEL MOULDING PROTECTOR
1. Install the protector with the 2 clips and screw.
INSTALL QUARTER PANEL WHEEL OPENING MOULDING LH (See INSTALLATION )
INSTALL FRONT FENDER WHEEL OPENING MOULDING LH (See INSTALLATION )