FOOTWELL Light: Inspection

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FOOTWELL LIGHT

Disconnect the E53 or E54 footwell light connector.

Measure the voltage according to the value(s) in the tables below.

Standard voltage: LH Side

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
E53-2 - E53-1	Any door is opened.	10 to 14 V
	Any door is unlocked when the engine switch is off and all doors are closed.	10 to 14 V
	The engine switch is turned from off to on (IG) when all doors are closed.	10 to 14 V
	The engine switch is turned from on (IG) to off when all door are closed.	Below 1 V
	All doors are locked when the engine switch is off.	Below 1 V

Fig 1: Identifying E53 And E54 Connectors Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RH Side

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
E54-2 - E54-1	Any door is opened.	10 to 14 V
	Any door is unlocked when the engine switch is off and all doors are closed.	10 to 14 V
	The engine switch is turned from off to on (16) when all doors are closed.	10 to 14 V
	The engine switch is turned from on (16) to off when all door are closed.	Below 1 V
	All doors are locked when the engine switch is off.	Below 1 V

If the result is not as specified, there is a malfunction on the wire harness side.

Apply battery voltage to the footwell light connector.

Check that the footwell light comes on.

MEASUREMENT CONDITION

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1	Footwell light comes on

If the result is not as specified, replace the footwell light assembly.

Fig 2: Identifying E53 And E54 Connectors Terminals (Components Side)