Navigation Ecu: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NAVIGATION ECU
1. Install the navigation ECU with the 4 screws.
  
  Fig 1: Installing Navigation ECU
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connectors.
  
  Fig 2: Identifying Navigation ECU Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL MULTI-DISPLAY ASSEMBLY See step 4
INSTALL NO. 2 RADIO BRACKET . Refer to INSTALLATION - Step 6
INSTALL NO. 1 RADIO BRACKET . Refer to INSTALLATION - Step 7
INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY . Refer to INSTALLATION - Step 8
INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL . Refer to INSTALLATION - Step 36
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to INSTALLATION - Step 37
INSTALL FRONT ASH RECEPTACLE ASSEMBLY . Refer to INSTALLATION - Step 41
INSTALL CONSOLE PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 42
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH . Refer to INSTALLATION - Step 43
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH . Refer to INSTALLATION - Step 44
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY . Refer to INSTALLATION - Step 45
INSERT MAP DISC
1. Remove the clock assembly.
  
  Fig 3: Removing Clock Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the engine switch on (ACC).
3. Insert the map disc.
4. Check that the wire harness is in the position shown in the illustration.
  
  Fig 4: Checking Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Engage the 2 clamps and install the clock assembly.
  
  Fig 5: Installing Clock Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST CLOCK