Rear Speed Sensor: Installation: Installation

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the rear axle hub and bearing assembly. Refer to INSTALLATION - Step 1 .
  HINT:
  - The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
  - If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
INSPECT REAR AXLE HUB BEARING LOOSENESS . Refer to ON-VEHICLE INSPECTION - Step 8
INSPECT REAR AXLE HUB RUNOUT . Refer to ON-VEHICLE INSPECTION - Step 9
INSTALL REAR DISC . Refer to INSTALLATION - Step 1
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY . Refer to INSTALLATION - Step 5
CONNECT REAR SPEED SENSOR WIRE
1. Connect the rear speed sensor wire connector to the rear speed sensor.
  
  Fig 1: Connecting The Rear Speed Sensor Wire Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SUSPENSION ARM COVER . Refer to INSTALLATION - Step 14
ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL . Refer to ADJUSTMENT - Step 2
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG . Refer to INSTALLATION - Step 2
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
1. Connect the cable to the negative (-) battery terminal and close the front luggage compartment trim cover.
2. Connect the reservoir level switch connector.
3. Clear the DTCs. Refer to DTC CHECK / CLEAR .
INSTALL LUGGAGE COMPARTMENT FLOOR MAT . Refer to INSTALLATION - Step 3
CHECK FOR SPEED SENSOR SIGNAL