Rear Speed Sensor: Installation: Installation

WARNING: This page is about a different car, the 2010 Lexus GS 450h. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

WARNING:

When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid pressure may increase.

INSTALL REAR SPEED SENSOR LH
1. Install the sensor with the bolt.
  
  Fig 1: Identifying Bolt Of Speed Sensor Rear LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE:
  Prevent foreign matter from attaching to the sensor tip.
2. Connect the sensor connector.
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK SPEED SENSOR SIGNAL
1. Check the speed sensor signal. Refer to TEST MODE PROCEDURE .