FixVault
Home › Lexus › 2010 › IS 250C Standard › Repair and Diagnosis › Engine Mechanical › Lubrication System › Lubrication (Service Information) › Oil Level Sensor › Installation › Installation

Oil Level Sensor: Installation: Installation

  1. INSTALL ENGINE OIL LEVEL SENSOR 
    1. Install a new gasket to the engine oil level sensor.
    2. Install the engine oil level sensor with the 4 bolts.
      Fig 1: Identifying Engine Oil Level Sensor Connector
      GTY263459Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      HINT: 

      Be sure to clean the contact surface.

    3. Connect the engine oil level sensor connector.
  2. ADD ENGINE OIL  See step  5
  3. INSPECT FOR ENGINE OIL LEAK 
  4. CHECK ENGINE OIL LEVEL  . Refer to ON-VEHICLE INSPECTION - Step 2
  5. INSTALL NO. 2 ENGINE UNDER COVER 
  6. INSTALL NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY LH  . Refer to INSTALLATION - Step 94
  7. INSTALL NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY RH  . Refer to INSTALLATION - Step 95
  8. INSTALL FRONT FLOOR COVER LH  . Refer to INSTALLATION - Step 98
  9. INSTALL FRONT FLOOR COVER RH  . Refer to INSTALLATION - Step 99
About FixVault