FixVault
Home › Lexus › 2010 › IS 250C Standard › Repair and Diagnosis › External Pages › Different car › Section 222 (Brake Control (Service Information)) › Steering Angle Sensor › Installation › Installation

Steering Angle Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS 350 and 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable sub-assembly.
      Fig 1: Identifying Steering Angle Sensor & Claws
      GTY128360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  . Refer to INSTALLATION - Step 2
  3. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION - Step 7
  4. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 9
  5. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  6. INSTALL NO. 3 LOWER STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  7. INSTALL NO. 2 LOWER STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  8. INSPECT STEERING WHEEL CENTER POINT 
    1. Inspect the steering wheel center point.
  9. CONNECT BATTERY NEGATIVE TERMINAL 
  10. INSPECT STEERING PAD  . Refer to INSTALLATION - Step 5
  11. INSPECT SRS WARNING LIGHT 

    HINT: 

    Refer to DIAGNOSIS SYSTEM

About FixVault