Charging (Service Information): Generator: Removal: Removal

PRECAUTION (w/ Navigation System for HDD)
NOTE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE COOL AIR INTAKE DUCT SEAL . Refer to REMOVAL - Step 1
REMOVE ENGINE ROOM SIDE COVER LH . Refer to REMOVAL - Step 2
REMOVE V-BANK COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 4
REMOVE INLET NO. 1 AIR CLEANER . Refer to REMOVAL - Step 27
REMOVE V-RIBBED BELT . Refer to REMOVAL - Step 4
DRAIN ENGINE COOLANT . Refer to REPLACEMENT - Step 5
REMOVE NO. 1 RADIATOR HOSE . Refer to REMOVAL - Step 19
REMOVE NO. 2 ENGINE COVER . Refer to REMOVAL - Step 3
REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY . Refer to REMOVAL - Step 19
DISCONNECT WIRE HARNESS
1. Remove the 3 nuts (A) and disconnect the wire harness.
  
  Fig 1: View Of Disconnecting Wire Harness Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 2 connectors (B).
REMOVE GENERATOR ASSEMBLY
1. Remove the terminal cap.
  
  Fig 2: Identifying Generator Assembly Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut (A) and disconnect the wire harness from terminal B.
3. Remove the bolt (B) and clamp bracket.
4. Disconnect the generator connector, and detach the 2 clamps.
5. Remove the nut, and disconnect the generator bracket.
  
  Fig 3: Identifying Bracket Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 2 bolts and generator.
  
  Fig 4: Identifying Bolts And Generator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the 2 bolts and 2 generator brackets.
  
  Fig 5: View Of Removing Generator Brackets Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002