Pattern Select Switch: Inspection: Inspection

REMOVE NO. 1 PATTERN SELECT SWITCH ASSEMBLY

Fig 1: Identifying Pattern Select Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
4 (P) - 3 (E)	Pattern select (PWR) switch on	Below 1 Ω
4 (P) - 3 (E)	Pattern select (PWR) switch off	10 kΩ or higher
2 (2ND) - 3 (E)	Pattern select (2ND) switch continuously pressed	Below 1 Ω
2 (2ND) - 3 (E)	Pattern select (2ND) switch released	10 kΩ or higher

If the result is not as specified, replace the No. 1 pattern select switch assembly.