FixVault
Home › Lexus › 2011 › GS 350 AWD › Repair and Diagnosis › External Pages › Different car › Section 21 (Engine Control (Service Information)) › Engine Coolant Temperature Sensor › Installation › Installation

Engine Coolant Temperature Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL E.F.I. ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the E.F.I. engine coolant temperature sensor.
      Fig 1: Locating EFI Engine Coolant Temperature Sensor Connector
      GTY148775Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the E.F.I engine coolant temperature sensor.

      Torque: 21 N*m ( 214 kgf*cm, 15 ft.*lbf) 

    3. Connect the E.F.I. engine coolant temperature sensor connector.
  2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  See step  2
  3. ADD ENGINE COOLANT  . Refer to REPLACEMENT - Step 4
  4. INSPECT FOR COOLANT LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
  5. INSTALL COOL AIR INTAKE DUCT SEAL  . Refer to INSTALLATION - Step 94
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 95
  7. INSTALL ENGINE UNDER COVER 
About FixVault