FixVault
Home › Lexus › 2011 › GS 450h › Repair and Diagnosis (Single Page) › Engine Performance › Ignition System › Ignition System (Service Information) › Ignition Coil And Spark Plug › Installation › Installation

Ignition Coil And Spark Plug: Installation: Installation

  1. INSTALL SPARK PLUG 
    1. Install the 6 spark plugs.

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

  2. INSTALL IGNITION COIL ASSEMBLY 
    1. Install the 6 ignition coils with the 6 bolts.
      Fig 1: Identifying Ignition Coil Connectors And Bolts
      GTY102264Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the 6 ignition coil connectors.
      3. Fig 2: Locating Wire Harness Clamps
      GTY122570Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Attach the 3 wire harness clamps and connect the noise filter connector.
  3. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE  . Refer to INSTALLATION - Step 2
  4. INSTALL NO. 2 VENTILATION HOSE  . Refer to INSTALLATION - Step 3
  5. INSTALL V-BANK COVER  . Refer to INSTALLATION - Step 31
  6. INSTALL ENGINE ROOM SIDE COVER LH  . Refer to INSTALLATION - Step 32
  7. INSTALL ENGINE ROOM SIDE COVER RH  . Refer to INSTALLATION - Step 33
  8. INSTALL COOL AIR INTAKE DUCT SEAL  . Refer to INSTALLATION - Step 34
  9. INSTALL SERVICE PLUG GRIP  . Refer to INSTALLATION - Step 33
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. PERFORM INITIALIZATION 
    1. Perform initialization. Refer to INITIALIZATION .
      NOTE:

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

About FixVault