| Engine does not crank (Does not start) |
Smart access system with push-button start |
Refer to HOW TO PROCEED WITH TROUBLESHOOTING |
| Immobiliser system |
Refer to HOW TO PROCEED WITH TROUBLESHOOTING |
| ECM power source circuit |
Refer to ECM Power Source Circuit |
| VC output circuit |
Refer to VC Output Circuit |
| Cranking holding function circuit |
Refer to Cranking Holding Function Circuit |
| Starter |
Refer to INSPECTION |
| No initial combustion (Does not start) |
ECM power source circuit |
Refer to ECM Power Source Circuit |
| VC output circuit |
Refer to VC Output Circuit |
| Fuel pump control circuit |
Refer to Fuel Pump Control Circuit |
| Crankshaft position sensor |
Refer to ON-VEHICLE INSPECTION |
| Ignition system |
Refer to ON-VEHICLE INSPECTION |
| Fuel injector circuit |
Refer to DTC P0201: Injector Circuit / Open - (Cylinder 1); DTC P0202: Injector Circuit / Open - (Cylinder 2); DTC P0203: Injector Circuit / Open - (Cylinder 3); DTC P0204: Injector Circuit / Open - (Cylinder 4); DTC P0205: Injector Circuit / Open - (Cylinder 5); DTC P0206: Injector Circuit / Open - (Cylinder 6); DTC P0207: Injector Circuit / Open - (Cylinder 7); DTC P0208: Injector Circuit / Open - (Cylinder 8); DTC P062D: Fuel Injector Driver Circuit Performance Bank1; DTC P062E: Fuel Injector Driver Circuit Performance Bank2 |
| Valve timing |
Refer to PROCEDURE - Step 3 |
| Engine cranks normally but difficult to start |
Fuel pump control circuit |
Refer to Fuel Pump Control Circuit |
| Fuel pump for high pressure |
Refer to ON-VEHICLE INSPECTION |
| Compression |
Refer to ON-VEHICLE INSPECTION - Step 9 |
| Engine coolant temperature sensor |
Refer to INSPECTION |
| Ignition system |
Refer to ON-VEHICLE INSPECTION |
| Fuel injector circuit |
Refer to DTC P1276: Port Injector Circuit No. 1; DTC P1277: Port Injector Circuit No. 2; DTC P1278: Port Injector Circuit No. 3; DTC P1279: Port Injector Circuit No. 4; DTC P127A: Port Injector Circuit No. 5; DTC P127B: Port Injector Circuit No. 6; DTC P127C: Port Injector Circuit #7; DTC P127D: Port Injector Circuit #8 |
| Intake system |
Refer to ON-VEHICLE INSPECTION |
| Throttle body |
Refer to ON-VEHICLE INSPECTION |
| ECM power source circuit |
Refer to ECM Power Source Circuit |
| Incomplete intermittent combustion occurs (Does not start) |
Fuel pump control circuit |
Refer to Fuel Pump Control Circuit |
| Ignition system |
Refer to ON-VEHICLE INSPECTION |
| Fuel line |
- |
| Fuel injector for direct injection |
Refer to INSPECTION |
| Fuel injector for port injection |
Refer to INSPECTION |
| Crankshaft position sensor |
Refer to ON-VEHICLE INSPECTION |
| High engine speed (Poor idle) |
Air conditioning signal circuit |
Refer to PROBLEM SYMPTOMS TABLE |
| Throttle body |
Refer to ON-VEHICLE INSPECTION |
| Throttle body control |
- |
| Engine coolant temperature sensor |
Refer to INSPECTION |
| PCV hose |
Refer to ON-VEHICLE INSPECTION |
| PCV system |
Refer to ON-VEHICLE INSPECTION |
| Low engine idle speed (Poor idle) |
Fuel pump control circuit |
Refer to Fuel Pump Control Circuit |
| Fuel pump for high pressure |
Refer to ON-VEHICLE INSPECTION |
| Electronic throttle control system |
Refer to DTC P0120: Throttle / Pedal Position Sensor / Switch "A" Circuit Malfunction; DTC P0121: Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem; DTC P0122: Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input; DTC P0123: Throttle / Pedal Position Sensor / Switch "A" Circuit High Input; DTC P0220: Throttle / Pedal Position Sensor / Switch "B" Circuit; DTC P0222: Throttle / Pedal Position Sensor / Switch "B" Circuit Low Input; DTC P0223: Throttle / Pedal Position Sensor / Switch "B" Circuit High Input; DTC P2135: Throttle / Pedal Position Sensor / Switch "A" / "B" Voltage Correlation |
| Intake system |
Refer to ON-VEHICLE INSPECTION |
| PCV hose |
Refer to ON-VEHICLE INSPECTION |
| Rough idle |
Compression |
Refer to ON-VEHICLE INSPECTION - Step 9 |
| Air fuel ratio sensor |
Refer to ON-VEHICLE INSPECTION |
| Heated oxygen sensor |
Refer to ON-VEHICLE INSPECTION |
| Mass air flow meter |
Refer to ON-VEHICLE INSPECTION |
| Ignition system |
Refer to ON-VEHICLE INSPECTION |
| Air conditioning signal circuit |
Refer to PROBLEM SYMPTOMS TABLE |
| Fuel line (clocked) |
- |
| Fuel pump for high pressure |
Refer to ON-VEHICLE INSPECTION |
| Electronic throttle control system |
Refer to DTC P0120: Throttle / Pedal Position Sensor / Switch "A" Circuit Malfunction; DTC P0121: Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem; DTC P0122: Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input; DTC P0123: Throttle / Pedal Position Sensor / Switch "A" Circuit High Input; DTC P0220: Throttle / Pedal Position Sensor / Switch "B" Circuit; DTC P0222: Throttle / Pedal Position Sensor / Switch "B" Circuit Low Input; DTC P0223: Throttle / Pedal Position Sensor / Switch "B" Circuit High Input; DTC P2135: Throttle / Pedal Position Sensor / Switch "A" / "B" Voltage Correlation |
| Intake system |
Refer to ON-VEHICLE INSPECTION |
| PCV hose |
Refer to ON-VEHICLE INSPECTION |
| Hunting (Poor idle) |
PCV hose |
Refer to ON-VEHICLE INSPECTION |
| Mass air flow meter |
Refer to ON-VEHICLE INSPECTION |
| Air fuel ratio sensor |
Refer to ON-VEHICLE INSPECTION |
| Hesitation/Poor acceleration (Poor driveability) |
Fuel line |
- |
| Fuel pump for high pressure |
Refer to ON-VEHICLE INSPECTION |
| Mass air flow meter |
Refer to ON-VEHICLE INSPECTION |
| Valve timing |
Refer to PROCEDURE - Step 3 |
| Throttle body |
Refer to ON-VEHICLE INSPECTION |
| Knock sensor |
Refer to INSPECTION |
| Brake override system |
Refer to Brake Override System |
| Surging (Poor driveability) |
Fuel line |
- |
| Fuel pump control circuit |
Refer to Fuel Pump Control Circuit |
| Fuel pump for high pressure |
Refer to ON-VEHICLE INSPECTION |
| Ignition system |
Refer to ON-VEHICLE INSPECTION |
| Fuel injector for port injection |
Refer to INSPECTION |
| Fuel injector for direct injection |
Refer to INSPECTION |
| Engine stalls soon after starting |
Mass air flow meter |
Refer to ON-VEHICLE INSPECTION |
| Intake system |
Refer to ON-VEHICLE INSPECTION |
| Fuel line |
- |
| Engine stalls during A/C operation |
Air conditioning signal circuit (compressor circuit) |
Refer to HOW TO PROCEED WITH TROUBLESHOOTING |
| ECM |
Refer to REMOVAL |
| Unable/difficult to refuel |
Refueling valve (canister) |
Refer to INSPECTION |