FixVault
Home › Lexus › 2011 › IS 250C Automatic › Repair and Diagnosis (Single Page) › External Pages › Different car › Section 344 (Brake Control System (Service Information)) › Steering Angle Sensor › Installation › Installation

Steering Angle Sensor: Installation: Installation

WARNING: This page is about a different car, the 2011 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the 6 claws and install the steering angle sensor to the spiral cable.
      Fig 1: Identifying Claws
      GTY128360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR  . Refer to INSTALLATION - Step 2
  3. INSTALL STEERING COLUMN COVER  . Refer to INSTALLATION - Step 11
  4. ADJUST SPIRAL CABLE  . Refer to INSTALLATION - Step 4
  5. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 10
  6. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  7. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  8. INSTALL LOWER NO. 3 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  9. INSPECT STEERING WHEEL CENTER POINT 
    1. Inspect the steering wheel center point.
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. INSPECT STEERING PAD  . Refer to INSTALLATION - Step 5
  12. INSPECT SRS WARNING LIGHT 

    HINT: 

    Refer to DIAGNOSIS SYSTEM

About FixVault