Toe Control Link: Removal: Removal

REMOVE REAR WHEEL
REMOVE TOE CONTROL LINK
1. Disconnect the skid control sensor connector.
  
  Fig 1: Identifying Skid Control Sensor Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt and separate the skid control sensor wire from the toe control link.
3. Remove the nut on the axle carrier side.
4. Using SST, disconnect the toe control link.
  
  Fig 2: Disconnecting Toe Control Link
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09628-00011
  NOTE:
  - Securely tie the string of the SST to the vehicle.
  - Do not damage the dust cover.
  - Securely set the SST on the spacer of the axle carrier.
  - If the spacer of the axle carrier comes off, replace the axle carrier with a new one.
5. Put matchmarks on the rear No. 2 suspension toe adjust plate and rear suspension member.
  
  Fig 3: Identifying Matchmarks On Rear No. 2 Suspension Toe Adjust Plate And Rear Suspension Member
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the nut, rear suspension toe adjust cam assembly, rear No. 2 suspension toe adjust plate, and toe control link.