FixVault
Home › Lexus › 2011 › IS 350C › Repair and Diagnosis › Accessories & Equipment › Infotainment › Navigation System (Service Information) › Multi-Display › Removal › Removal

Navigation System (Service Information): Multi-Display: Removal: Removal

  1. PRECAUTION (w/ Navigation System for HDD) 

    Refer to PRECAUTION

    NOTE:
    • After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
    • A hard disk drive (HDD) is built into the display and navigation module display to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the display and navigation module display.
    • When removing or installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD) 
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  . Refer to REMOVAL - Step 5
  4. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  . Refer to REMOVAL - Step 9
  5. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  . Refer to REMOVAL - Step 10
  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)  . Refer to REMOVAL - Step 4
  7. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission)  . Refer to REMOVAL - Step 6
  8. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission)  . Refer to REMOVAL - Step 7
  9. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)  . Refer to REMOVAL - Step 8
  10. REMOVE INSTRUMENT PANEL COIN BOX (w/o Ashtray)  . Refer to REMOVAL - Step 11
  11. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray)  . Refer to REMOVAL - Step 12
  12. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY  . Refer to REMOVAL - Step 17
  13. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL  . Refer to REMOVAL - Step 18
  14. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY  . Refer to REMOVAL - Step 18
  15. REMOVE HARD DISK DRIVE (w/ Navigation System for HDD)  See step  15
  16. REMOVE NO. 1 RADIO BRACKET  . Refer to REMOVAL - Step 19
  17. REMOVE NO. 2 RADIO BRACKET  . Refer to REMOVAL - Step 20
  18. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY 
    1. Slide the display and navigation module display assembly in the direction shown by the arrow to remove it.
      Fig 1: Sliding Integration Control Panel
      GTY280881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE CLOCK ASSEMBLY  . Refer to REMOVAL - Step 24
  20. REMOVE NAVIGATION ECU (w/ Navigation System for DVD)  See step  17
  21. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY 
About FixVault