DTC C1420: Acceleration Sensor Malfunction: Procedure

1. Check that the yaw rate and acceleration sensor has been installed properly. Refer to INSTALLATION .

   OK

   The sensor is tightened to the specified torque.

   The sensor is not installed in a tilted position.

   NOTE:

   Check the yaw rate and acceleration sensor signal after replacement. Refer to TEST MODE PROCEDURE .

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .

NG → See step   3 

OK → See step   2