Door Control Receiver: Inspection: Inspection
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT DOOR CONTROL RECEIVER
- Disconnect the door control receiver connector.
- Measure the voltage according to the value(s) in the table below.
Standard voltage
Tester Connection Condition Specified Condition L10-5 (+B) - Body ground Always 10 to 14 V - Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Connection Condition Specified Condition L10-1 (GND) - Body ground Always Below 1 Ω If the result is not as specified, there may be a malfunction on the wire harness side.