Starting System (Service Information): Starter: Installation: Installation

INSTALL FLYWHEEL HOUSING SIDE COVER
INSTALL STARTER ASSEMBLY
1. Install the starter with the 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
2. Connect the starter connector.
3. Connect the starter wire with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
4. Attach the starter wire clamp.
INSTALL STARTER COVER
1. Install the starter cover with the 3 bolts.
  Torque: 12 N*m (117 kgf*cm, 8 ft.*lbf)
INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
Refer to INSTALLATION
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .