FixVault
Home › Lexus › 2012 › IS 250 Base, RWD, Automatic › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel System (Service Information) › Fuel Pump Resistor › Removal › Removal

Fuel Pump Resistor: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 1
  3. REMOVE ENGINE ROOM RH SIDE COVER  . Refer to REMOVAL - Step 3
  4. REMOVE FUEL PUMP RESISTOR 
    1. Disconnect the connector and clamp from the fuel pump resistor.
      Fig 1: Location of Bolts, Fuel Pump Resistor And Ground Wires
      GTY146373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and fuel pump resistor, and disconnect the ground wires.
About FixVault