Cold Start Injector: Removal: Removal

PRECAUTION (w/ Navigation System for HDD)
NOTE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
DISCHARGE FUEL SYSTEM PRESSURE
HINT:

Refer to PRECAUTION .
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE V-BANK COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 4
REMOVE COLD START FUEL INJECTOR ASSEMBLY
1. Disconnect the cold start injector connector.
2. Remove the bolt and 2 gaskets, and disconnect the fuel tube from the cold start injector.
  
  Fig 1: Identifying Fuel Tube From Cold Start Injector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Do not fold or bend the hose.
3. Remove the 2 bolts, gasket and cold start fuel injector assembly from the surge tank.
  
  Fig 2: Cold Start Injector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002