FixVault
Home › Lexus › 2012 › IS F › Repair and Diagnosis › Electrical › Starter › Starting System (Service Information) › Relay › On-Vehicle Inspection › On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT STARTER RELAY 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Inspecting Starter Relay (ST)
      GTY120666Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 When battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 When battery voltage is applied to terminals 1 and 2 Below 1 Ω

      If the resistance is not as specified, replace the relay.

  2. INSPECT STARTER CUT RELAY 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 2: Inspecting Starter Relay (ST)
      GTY120666Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Terminal Connection Condition Specified Condition
      3 - 5 When battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 When battery voltage is applied to terminals 1 and 2 Below 1 Ω

      If the resistance is not as specified, replace the relay.

About FixVault