Headlight Assembly: Removal: Removal

WARNING: This page is about a different car, the 2012 Lexus LS 460. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:

w/ Navigation System (for HDD):

After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

Condition	Waiting Time
Vehicle enrolled in safety connect system	6 minutes
Vehicle not enrolled in safety connect system	1 minute

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

REMOVE FRONT BUMPER COVER
1. Remove the front bumper cover. Refer to REMOVAL .
REMOVE HEADLIGHT ASSEMBLY LH

Fig 1: Identifying Headlight Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the 3 bolts and remove the headlight.
2. Disconnect the connector.