On-Vehicle Inspection [09/2014 - 10/2015]: Procedure
- CHECK MASS AIR FLOW METER SUB-ASSEMBLY
- Read the value using the Techstream (MAF).NOTE:
- Turn off the engine.
- Perform the inspection with the vehicle indoors and on a level surface.
- Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).
- During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.
- Turn the engine switch on (IG) (do not run the engine).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
- Wait 30 seconds, and read the values on the Techstream.
Standard Condition
Item Condition Specified Condition MAF - Engine not running
- 30 seconds after turning engine switch on
0.57 g/sec or less - If the result is not as specified, replace the mass air flow meter sub-assembly.
- If the result is as specified, inspect the mass air flow meter sub-assembly (Refer to INSPECTION [09/2014 - 10/2015] ).
- Read the value using the Techstream (MAF).