FixVault
Home › Lexus › 2016 › ES 350 › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (Service Information) › Combination Switch › Inspection [07/2015 - ] › Procedure

Inspection [07/2015 - ]: Procedure

  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY 
    1. Inspect ECO mode switch
      1. Measure the resistance according to the value(s) in the table below.
        GTY654314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 (ECU) - 5 (E) ECO mode switch turned and held at ECO position Below 10 Ω
        ECO mode switch not turned 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Integration Control and Panel Assembly)

        If the result is not as specified, replace the integration control and panel assembly.

    2. Inspect NORMAL mode switch
      1. Measure the resistance according to the value(s) in the table below.
        GTY654312Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard Resistance

        Tester Connection Condition Specified Condition
        2 (B) - 5 (E) NORMAL mode switch pushed and held Below 10 Ω
        NORMAL mode switch not pushed 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Integration Control and Panel Assembly)

        If the result is not as specified, replace the integration control and panel assembly.

    3. Inspect SPORT mode switch
      1. Measure the resistance according to the value(s) in the table below.
        GTY681712Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 (P) - 5 (E) SPORT mode switch turned and held at SPORT position Below 10 Ω
        SPORT mode switch not turned 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Integration Control and Panel Assembly)

        If the result is not as specified, replace the integration control and panel assembly.

    4. Inspect VSC off switch
      1. Measure the resistance according to the value(s) in the table below.
        GTY398399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard Resistance

        Tester Connection Condition Specified Condition
        7 (+) - 5 (E) VSC off switch pushed and held Below 10 Ω
        VSC off switch not pushed 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Integration Control and Panel Assembly)

        If the result is not as specified, replace the integration control and panel assembly.

    5. Inspect illumination
      1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the integration control and panel assembly.
        GTY683481Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard

        Measurement Condition Specified Condition
        Battery positive (+) → 8 (ILL+) Battery negative (-) → 6 (ILL-) Illuminates
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Integration Control and Panel Assembly)
        *b Integration Control and Panel Assembly Illumination

        If the result is not as specified, replace the integration control and panel assembly.

About FixVault