FixVault
Home › Lexus › 2016 › LS 600h › Repair and Diagnosis › Brakes › Traction Control › Brake Control System - Service Information › Skid Control Buzzer › Removal [09/2015 - ] › Procedure

Removal [09/2015 - ]: Procedure

  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  2. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  3. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Disable the AUTO TILT AWAY function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] ).
      NOTE:

      Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

    2. Turn the power switch ON (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
    3. Turn the power switch OFF and disconnect the cable from the negative (-) battery terminal.
      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    (Refer to REMOVAL [09/2015 - ] )

  6. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    NOTE:

    If the buzzer connector is disconnected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to remove the buzzer according to the procedures below.

    1. Detach the clamp and disconnect the buzzer from the extension panel.
      GTY685879Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector and remove the buzzer.
About FixVault