Inspection [09/2015 - ]: Procedure
- INSPECT TEMPERATURE SENSOR
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - Body ground Always 10 kΩ or higher 2 - Body ground Always 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Temperature Sensor) - Immerse the sender portion of the temperature sensor in the Toyota Genuine ATF that has been prepared in a container.
- While warming the Toyota Genuine ATF, measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection ATF Temperature Specified Condition 1 - 2 20°C (68°F) 10.3 to 13.9 kΩ 115°C (239°F) 657.1 to 726.3 Ω WARNING:Do not overheat. Otherwise, fire may occur.
If the result is not as specified, replace the temperature sensor.
- Measure the resistance according to the value(s) in the table below.