Inspection [09/2015 - ]: Procedure

INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD RESISTANCE

Tester Connection	Switch Condition	Specified Condition
8 (P) - 1 (E)	SPORT S or SPORT S+ mode switch turned and held at SPORT S or SPORT S+ position	Below 1 Ω
8 (P) - 1 (E)	SPORT S or SPORT S+ mode switch not turned	10 kΩ or higher
6 (ECU) - 1 (E)	COMF or ECO mode switch turned and held at COMF or ECO position	Below 1 Ω
6 (ECU) - 1 (E)	COMF or ECO mode switch not turned	10 kΩ or higher
19 (2nd) - 1 (E)	Mode switch (ECT 2nd) on	Below 1 Ω
19 (2nd) - 1 (E)	Mode switch (ECT 2nd) off	10 kΩ or higher
7 (B) - 1 (E)	NORMAL mode switch pushed and held	Below 1 Ω
7 (B) - 1 (E)	NORMAL mode switch not pushed	10 kΩ or higher

TEXT IN ILLUSTRATION

*a	Component without harness connected (Integration Control and Panel Assembly)

If the result is not as specified, replace the integration control and panel assembly.