FixVault
Home › Lexus › 2017 › GS 450h Base › Repair and Diagnosis › Engine Mechanical › Lubrication System › Engine Lubrication System (Service Information) › Oil Pressure Switch › Installation [09/2014 - ] › Procedure

Installation [09/2014 - ]: Procedure

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch.

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      NOTE:

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch.

    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine for at least 1 hour after installation.

    3. Connect the engine oil pressure switch connector.
  2. ADD ENGINE OIL 

    See step  5

  3. INSPECT FOR OIL LEAK 

    See step  6

  4. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 2

  5. INSTALL NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 75 or PROCEDURE - Step 75

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 117 Refer to PROCEDURE - Step 116

  7. INSTALL ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 118 Refer to PROCEDURE - Step 117

About FixVault