Inspection [09/2014 - 11/2017]: Procedure

INSPECT FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)

NOTE:

Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
If a fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.

Check the fuel pressure sensor output voltage.

Apply 5 V between terminals 3 (VC) and 1 (E2).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Fuel Pressure Sensor)
*b	Voltage applied between terminals

NOTE:

Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 3 (VC) and 1 (E2).

HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.

Measure the voltage between terminals.

Standard Voltage

Tester Connection	Condition	Specified Condition
2 (PR) - 1 (E2)	Pressure not applied to fuel pressure sensor	Approximately 0.5 V*

*: The output voltage changes depending on the voltage applied to the terminals. Output voltage = (0.1 x Voltage applied to terminals)

If the result is not as specified, replace the fuel delivery pipe sub-assembly (fuel pressure sensor).

*a	Component without harness connected (Fuel Pressure Sensor)