FixVault
Home › Lexus › 2017 › RC 300 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System (2GR-FSE) - Service Information › Camshaft Position Sensor › Removal [09/2014 - 11/2017] › Procedure

Removal [09/2014 - 11/2017]: Procedure

  1. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 4 [10/2015 - 11/2017]

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY396259Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1) 
    1. Disconnect the VVT sensor connector.
      GTY464458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY396319Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2) 
    1. Disconnect the VVT sensor connector.
      GTY470338Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.
      NOTE:

      If the VVT sensor has been struck or dropped, replace it.

About FixVault