- INSTALL BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY
- Install the brake control power supply with bracket assembly to the vehicle body with the 2 nuts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Connect the connector to the brake control power supply with bracket assembly.
- INSTALL FUEL PUMP CONTROL ECU BRACKET
- Install the fuel pump control ECU bracket to the vehicle body with the 2 bolts and nut.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
- Attach the clamp.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Connect the 2 fuel pump control ECU connectors.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Connect the brake control power supply connector.
- INSTALL NO. 1 DECK BOARD BRACKET LH
- Install the No. 1 deck board bracket LH with the bolt and nut.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
Torque: 15.75 N.m (161 kgf/cm, 12 ft.lbf)
- INSTALL INNER LUGGAGE COMPARTMENT TRIM COVER LH
Refer to REASSEMBLY [05/2023 - ]
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to INSTALLATION [05/2023 - ]
- CHECK AND CLEAR DTC
Refer to DTC CHECK / CLEAR [09/2018 - ]
- INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Refer to AUTOMATIC LEARNING CHART [05/2023 - ]